新闻中心
|
使用木工机械需要注意的问题1、加工时的安全要点。木工机械上应装设合适的安全防护装置和吸尘、排屑装置。凡外露的皮带轮、转盘或旋转轴都应有的防护罩,防止把衣袖卷进去。 2、使用木工机械时,要穿紧袖口的工作服,不准戴手套,禁止穿宽松式的衣服,女工的头发一定要套在工作帽内。 3、木工机械的刀轴应与电器有联锁。避免在拆装或更换刀具时,误触电钮使刀具突然旋转而造成伤害。 4、在木料有飞出或下落的地方操作,应戴安全帽或穿劳保防护鞋。 5、木工机械要设法改进,安装自动进料装置和防护罩,以此防止人身受到伤害。 6、在木料有回弹危险的地方,应设防弹装置并要经常检查它的性。 7、新工人上机操作前,一定要行培训,操作上要达到一定的熟练程度,同时要了解各种伤害的可能性及防护方法。 8、机械周围要经常清理,防止工人被碎木绊倒或被木屑、刨花滑倒。 1. Safety points during processing. Woodworking machinery should be installed with appropriate safety protection devices and dust suction, chip removal devices. Any exposed pulley, turntable or rotating shaft should have a protective cover to prevent sleeves from being rolled in. 2, the use of woodworking machinery, to wear tight cuffs of work clothes, do not wear gloves, prohibited to wear loose clothes, women's hair must be set in the work cap. 3, woodworking machinery knife shaft should be interlocked with electrical appliances. Avoid damage caused by the sudden rotation of the tool caused by the false electric shock knob when disassembling or replacing the tool. 4, in the wood flying out or falling place operation, should wear a safety hat or wear labor protection shoes. 5, woodworking machinery to try to improve, install automatic feeding device and protective cover, in order to prevent personal injury. 6, in the wood where there is a risk of rebound, should set up a bomb device and often check its nature. 7, new workers on the machine before operation, must be trained, the operation to achieve a certain degree of proficiency, and to understand the possibility of various injuries and protection methods. 8, the machinery should be cleaned often around to prevent workers from falling over wood scraps or slipping by wood chips and shavings. 上一篇木工机械检验及方法下一篇木工机械设备的基础功能 |